Clothes For That Therière

Depending on the density of the viscos and the number of the threads, you're gonna need a 40-60 hinge. It's 5-10 centimetres of rubber 1x1. Close six hinges, tie 10-12 hinges and close six more. These are future loans. The hair between closed loops in width shall be equal to the breadth of the chest. It's a half-ass back (approximately 12 to 16 rows) and a half breast, 20 to 24 rows. We'll have to go back to the county without forgetting to dial six hinges for finalization. After about seven centimeters, you close 12 hinges at the center of your stomach. You keep tying half-ass, removing the loop from both sides. The last 12-14 hinges are locked in the straight. You pick up 30 hinges from each line and sleeve. Gorlovin, the long and the sleeves are tying the paycheck, the rows are closing on the face loop. You're holding the plugs around the throat and putting the lipsticks on it.

Main vents

Clothing the pants depends on the dog's floor. For the tubes of the terrier, a deep cut on the trouser should be left, its value determined individually. The width of the pants is taken in such a way that the animal can move freely, sit down, jack the laps. Almost all the pants have a back plug.

For the warmed model (for the picture below), the navigator and straps should be further removed. Well, we can get ready straps with a rubber from an old child's half-companion. The consignor is a rectangle whose width is equal to the breadth of the breast between the front legs and the length is the distance from the belt of the pants to the chest. The details of the pants are steamed by the two parts of the top, two of the heater(s) and two of the linings. Don't forget to leave the stitches and the plug valve. First, the synthes are estimated with the details of the substrate, then the substrate is sliding into the pants. The parts of the top are stacked separately, and the plug is set. The ready-to-be stack is placed inside the top pants of the Iznka. There's a groove and a strap, a rubber in the waist. The back is constructed or processed by the cant, the bottom of the stand is a rubber.